First, make sure you have all the materials! You'll need:
-
Hot Glue (be careful not to burn yourself)
-
Ram Mask cutouts
- 1 face piece (tabs 1-6)
- 1 helmet piece (tabs 7-11)
- 2 horn pieces (left/right, tabs 12-13)
Pre-fold each section inward along the perforated lines.
The exterior is indicated by numbered tabs. To construct the parts, start with the helmet, then the face and horns.
Fold each tab inward and glue to the inner side of the corresponding numbered panel.
Tabs 5-7 on the helmet and face sections will be left over from this step.
Some tabs on the horn pieces are not numbered. They are glued to the interior in the same way as numbered panels.
To finish the ends of the horn pieces, carefully hold and glue the tips together.
To connect all the parts of the mask, carefully glue and connect tabs 5-7 from the helmet and face sections.
The base of the left horn connects to the “LEFT” panel on the helmet, and the right horn connects to the “RIGHT” panel.
Decorate your finished mask and put it on to become the Ram!
EN 
ES